You are currently viewing How To Reset Blink Camera After Replacing Battery

How To Reset Blink Camera After Replacing Battery

  • Post author:
  • Post category:News
  • Post comments:0 Comments

How To Reset Blink Camera After Replacing Battery. Release the default button when the status led blinks. If the wifi name and password are the same as before, the camera will reconnect automatically.

Blink wireless security cameras run for two years on a pair of AA
Blink wireless security cameras run for two years on a pair of AA from www.theverge.com

Try unplugging your router for 30 seconds then connecting it again. How to turn off the blue recording led on blink xt remove the battery cover. Another good step is performing a reset, by holding the setup button for 20 seconds.

To The Right Of Your Camera's Serial Number, You'll See A Switch That Says Rec.

When the blink camera is blinking red and green, that signals that the camera has found the local ip address but cannot connect to the internet. If you reset the camera, the network settings will be adjusted so that dhcp can be enabled. Push down on the arrow on the battery cover of the blink xt camera.

The Sync Module Is Ready To Be Added Through The Blink App.

Press and hold for 10 seconds. Make sure your camera is powered on. If the wifi name and password are the same as before, the camera will reconnect automatically.

Insert Two New Lithium Batteries.

Click to see full answer. To the right of your camera's serial number, you'll see a switch that says rec. Try restarting the router to see if that corrects the issue.

Try Unplugging Your Router For 30 Seconds Then Connecting It Again.

Insert the pin into the factory reset recess located above the switch on the back of the camera. I fixed mine by bringing it in pulling the battery and letting it sit in front of a register for about an hour and then placed a new set of batteries in and no issue and it's had the same batteries for almost a year with no issue now. This is how you change the batteries on your blink wireless security camera.

Upon Inserting The Batteries, You Will Notice Five Led Flashes From The Front Of The Blink Camera.

Insert two new lithium batteries. Check to see if your camera responds to commands. The rest button is typically found near the usb port.

Leave a Reply