You are currently viewing How To Measure Trailer Axle Alignment

How To Measure Trailer Axle Alignment

  • Post author:
  • Post category:News
  • Post comments:0 Comments

How To Measure Trailer Axle Alignment. With weight applied to the suspension, the arc in the axle straightens and the wheels stay straight. Then take the same measurement to the other wheel center.

regjosamwheelalignmenttruckaligneriimeasuringfouraxletank
regjosamwheelalignmenttruckaligneriimeasuringfouraxletank from www.olego.dk

2.stretch the tape to the inside of the wheel on the other side of the trailer, again to the outer edge of. Take the tires off the rims, and bolt the 2 stub axles to them using the lug nuts. With weight applied to the suspension, the arc in the axle straightens and the wheels stay straight.

This Procedure Involves Several Steps:

They should be identical or within 1/8 of an inch, give or take 1/16 of an inch. 1.select your axle based on the current style you currently have on your trailer. Park on a level surface.

Do The Same On Both Sides Of The Trailer To Complete Your Trailer Axle Alignment Check.

Generally speaking, look for trailer axles with more capacity than you need. How to order an axle. Depends on how the load is situated.

Similarly, It Is Asked, How Do You Fix A Trailer Axle.

Take the tires off the rims, and bolt the 2 stub axles to them using the lug nuts. Measure from the straightedge to the frame in front of the wheel & record the measurement. Once you have the required tools, it’s time to measure the trailer alignment.

The Measurements From The Center To Each Tire On The Same Axle Should Be Within 1/8 Inch Of Each Other.

Measure and note the distance between the front wheel and rear wheel on either side of the trailer, if your trailer has a second axle. Consider that if a cambered axle such as the one pictured is rotated 180 degrees while retaining the current suspension orientation, it would cause a positive camber angle when the weight of the vehicle is applied. Clamp the angle iron to a bench vice or work mate, or something that will hold it steady.

Measurement # 2 = Spring Center.

Be sure to identify axle over or axle under springs when you select your part number. Choose the same spot on each hub and measure diagonally. The tech who worked on the trailer does a lot of trailers (boat, camper, etc).

Leave a Reply