You are currently viewing How To Manually Light Pilot Light On Gas Fireplace

How To Manually Light Pilot Light On Gas Fireplace

  • Post author:
  • Post category:News
  • Post comments:0 Comments

How To Manually Light Pilot Light On Gas Fireplace. After approximately one minute, release the gas control knob. If the pilot does not light, wait 5 minutes and try again.

How To Light the Pilot to Your Gas Fireplace or Stove
How To Light the Pilot to Your Gas Fireplace or Stove from www.heatnsweep.com

Turn the gas control knob counterclockwise so the indicator points to the “pilot” position. Relighting your heatilator® standing pilot fireplace video. Remove the access cover to the controls.

Read And Follow The Instructions That Came With Your Fireplace,.

Turn the gas control knob counterclockwise so the indicator points to the “pilot” position. Push in knob (this releases the gas to the pilot area only). Once the pilot is lit, continue to hold the valve knob in for 60 seconds, then slowly release.

Once The Pilot Lights, Keep Holding Down The Gas.

If the pilot light goes out, you’ll just need to dig deeper. Click to see full answer. Depress the gas control knob fully.

This Fireplace Has A Pilot Which Must Be Lit Manually.

Lighting the pilot on a gas fireplace.for your safety, read before lighting:a. It may take a few tries to get the fireplace to ignite. From off position, turn gas control knob (reads off, on & pilot) counterclockwise to pilot position.

Turn The Gas Control Knob Until The Pilot Setting Lines Up With The Arrow Or Hash Mark On The Outer Rim Of The Control.

Push the igniter button once every second until it lights. Push in the pilot knob, which will then manually send gas into the system. This would be a good time to clean the glass of any soot that you might have.

Wait Until You Are Ready To Ignite The Gas Fireplace Pilot Light Before Turning The Gas Valve Control Knob.

Depending on how long it’s been since the gas fireplace was last used, ignition may take several attempts before igniting. It should take a few attempts to light the pilot. This spark will ignite the pilot flame.

Leave a Reply