You are currently viewing How To Fix A Leaky Bathtub Faucet With One Handle

How To Fix A Leaky Bathtub Faucet With One Handle

  • Post author:
  • Post category:News
  • Post comments:0 Comments

How To Fix A Leaky Bathtub Faucet With One Handle. If you have a knob style handle, remove the handle button by prying off with a screwdriver, then unscrew the handle screw and remove the handle. Unscrew this screw with the help of a flat screwdriver and remove the handle.

How to repair a set of leaky 2 handle Moen washerless faucets. Easiest
How to repair a set of leaky 2 handle Moen washerless faucets. Easiest from www.youtube.com

Put a pipe joint to the bonnet threads and put it back to the faucet body. Unscrew the screw that holds the handle with. Once the cap is removed, you’ll find an exposed screw inside the handle that holds it in place.

Then, Turn On The Faucet To Release The Pressure And Remove Any Water That May Remain Inside The Water Lines And Faucet.

Put a pipe joint to the bonnet threads and put it back to the faucet body. Grease the new seat washer and the threads of the original screw and then put them where they belong. These washers are usually backed up by a spring on the rear side.

Stretch The Ring Off The Spout And Pull It Out Of The Faucet.

The reason behind your leaking bathtub faucet is a broken or damaged valve. A damaged o ring is the cause of a leaky faucet handle. How to fix a stripped faucet handle in 10 minutes or less.

You Will See 2 Washers, One On The Cold Water Line And The Other On The Cold Water Line.

Now, if you decide to hire an expert to do the job for you, you can expect to spend between $167 and $201. Take off the escutcheon plate around the faucet by removing the screws holding it in place. If you have a knob style handle, remove the handle button by prying off with a screwdriver, then unscrew the handle screw and remove the handle.

How To Fix A Leaking Bathtub Faucet.

If the faucet has two handles, only one of the valves may need servicing. If the faucet has a single handle, it has only one valve, and that's the only one you need to worry about. A screwdriver or a pocket knife will let you lever off the cap on top of the faucet handle screw.

This Means You Might Need To Shut The Water For The Whole House Off.

Third, pull off the old bonnet washer, grease the new one and slide it in place. Determine which valve needs servicing. Unscrew the screw and place it with the cap so you don’t lose it.

Leave a Reply